Robustel GoRugged R3000 - Interface->Ethernet

Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.3.0.3 04.02.2017 47 / 124
Confidential
3.8 Interface->Ethernet
This section allow user to set the parameter of the Ethernet port. One port should be assigned to lan0 a least.
Click button, configure the port setting.
Ethernet
Item
Description
Default
Index
The index of Ethernet port. Read only.
1 or 2
Port
eth0 or eth1
One port should be assigned to lan0 a least.
/
Port Assignment
Select lan0 or lan1.
Note: When eth0 used As WAN, lan1 is unavailable. Please go to System->Device
Configuration to enable eth0 used as WAN.
And lan1 available only if it was selected by eth0 or eth1 in this field.
lan0
User can check the status of Ethernets in this page.