54
Meter Maintenance and Troubleshooting
9
The blood glucose result has not been
sent to the default paired device. The
transfer is still pending.
Place meter and paired device closer
together.
The meter was unable to pair with a
device.
Retry the pairing.
The test strip may be damaged, not
properly inserted, or was previously used.
Remove and reinsert the test strip or
replace it if damaged or previously used.
A meter or test strip error has occurred.
This error message could appear if the
cap on the test strip container was not
closed tightly. The test strips may have
been damaged due to improper storage or
handling.
Never make therapy decisions based
on an error message.
Repeat the blood glucose test. If a second
E-3 error message appears, perform a
control test with the control solution and a
new test strip. See the section Performing
a Control Test in the chapter Control Tests.
If you continue to receive an E-3 error
message, use an alternate method for
testing your blood glucose, such as a
backup meter and test strip. If the
alternate method gives an extremely high
blood glucose result, or if an alternate
method is not available, contact your
healthcare professional immediately.
In rare cases, an E-3 error message may
indicate that your blood glucose is
extremely high and above the system’s
measuring range. See the Unusual Blood
Glucose Results section in the chapter
Blood Glucose Tests for other possible
causes of the error message.
82052_08100918004.indd 54 6/9/2020 12:09:17 PM
To Next Page
Loading...
Need help?
General
