4
> Do NOT overtighten the Ball Studs in the Upper Ball
Stud Plates.
> To prevent damage to the pivoting leg assembly,
make sure it is in the closed position when rotating the
Cabinet Verticals and Headboard to the upright position
during assembly.
> Be sure to properly orient the Gas Springs by noting the
location of the labels reading, “Mount this end up.”
PRODUCT SPECIFIC SAFETY WARNINGS
> To avoid serious injury, keep hands and fingers away from the spinning router bit. Maintain
awareness of the bit at all times.
> TO AVOID THE RISK OF SERIOUS INJURY, DO NOT
ALLOW CHILDREN TO PLAY ON THE BED UNIT OR
OPERATE IT WITHOUT ADULT SUPERVISION.
> IN CONSTRUCTING YOUR BED UNIT, DO NOT DEVIATE
FROM THESE INSTRUCTIONS. If you want to make
any modifications, first call 1-877-966-3852. Unapproved
modifications will void your warranty, might cause your bed
unit to not work correctly, and could result in serious injury
during use.
> You MUST have another ADULT help you while installing
your wall bed unit to make sure the bed doesn’t close
inadvertently while you are working. Failure to do so
increases the risk of serious injury.
> The components of this wall bed unit operate with stored
mechanical energy, which can cause serious injury if
mishandled. TO REDUCE THE RISK OF INJURY, THE
BED UNIT MUST BE CORRECTLY AND SECURELY
ANCHORED TO THE WALL, WITH THE CORRECT
FASTENERS FOR THE TYPE OF WALL, AS SPECIFIED
IN THESE INSTRUCTIONS.
> To reduce the risk of seriois injury, do NOT attempt to
lower the bed frame assembly until the bed cabinet has
been securely attached to the wall.
> The placement of fasteners in images in these instructions
is for illustration purposes only. To avoid the risk of serious
injury, you must correctly place and securely attach
fasteners in your wall.
> The Right and Left Side Rails (C and D) MUST be made
with 3/4" plywood (nominal thickness) because of the stress
placed on these parts and the need for greater strength and
structural integrity.
> The Top Header Rear Rail (L) MUST be attached securely
to the Top Header with glue and #8 x 2" Coarse-Thread
Screws. Failure to securely attach the Top Header Rear
Rail to the Top Header increases the chance that the bed
cabinet could detach and tip over, potentially resulting in
serious injury.
> The bed will not stay down without the weight of a mattress.
Operating the bed mechanism without a mattress in place
increases the risk of sudden closing, entrapment and
serious personal injury.
> Do NOT use drywall anchors.
> Do NOT use an impact driver to drive fasteners; the added
torque increases the risk of stripping the pilot holes and
weakening connections. Do NOT overtighten screws.
> Do NOT deviate from the required interior cabinet opening
dimensions listed for the bed size you will be building. An
improperly sized bed cabinet could create a safety hazard
and result in serious personal injury.
> Do NOT construct the cabinet from MDF, particleboard or
melamine-coated MDF or particleboard. The decreased
screw-holding ability of these materials increases the risk
of cabinet joint failure and serious personal injury.
> Mattress dimensions MUST NOT exceed 39" x 75" x 12"
thick, including pillowtop. Mattress MUST NOT weigh less
than 35 lbs. or more than 50 lbs. Do NOT use a foam or
very light mattress with this product.
> Turn off and unplug your router before installing the bit
or adjusting the cutter height.
To Next Page
Loading...
