Publication 2711C-UM001C-EN-P - September 2009 27
Configuration Mode Chapter 2
Configure the Screen Saver
You can enable or disable the screen saver on the connected
PanelView Component terminal.
The terminal has four screen saver modes: screen saver, dimmer,
screen saver and dimmer, or disable.
• Screen saver - activates after the idle timeout elapses using a
default screen saver image. The screen saver deactivates when
you press a key.
• Dimmer - dims the display from full brightness to the brightness
level you set when the idle timeout elapses. While the display is
dimmed, you can still see on-screen activity. When you press a
key, the display is restored to full brightness.
• Screen saver and dimmer - activates the screen saver and dims
the display when the idle timeout elapses.
• Disable screen saver and dimmer - keeps the display on.
The screen saver timeout is the amount of idle time that must elapse
before the screen saver, dimmer, or screen saver and dimmer
activates. The idle time can be adjusted between 1…60 minutes.
The brightness intensity of the screen saver or dimmer can be adjusted
between 1…100%.
Follow these steps to configure the screen saver using the PanelView
Explorer Startup window.
1. Go to the PanelView Explorer Startup window.
2. Click the Terminal Settings link.
3. Click the Display/Input tab.
4. Select a screen saver mode from the list.
To Next Page
Loading...
Need help?
General
