10 Rockwell Automation Publication 750-IN119A-EN-P - April 2022
Chapter 1 Product Overview
Product Safety
Waste Electrical and Electronic Equipment
ATTENTION: Hazard of personal injury or equipment damage due to
unexpected machine operation exists if the drive is configured to
automatically issue a Start or Run command. Do not use these functions
without considering applicable local, national and international codes,
standards, regulations or industry guidelines.
ATTENTION: A possible hazard of personal injury due to prolonged exposure
to high sound levels. Follow applicable local, national, and international
codes, standards, regulations, or industry guidelines for hearing protection
when exposed to potentially damaging noise hazards.
ATTENTION: An incorrectly applied or installed drive system can result in
component damage or a reduction in product life. Wiring or application errors
such as an under-sized motor, incorrect or inadequate AC supply, a corrosive
environment, or excessive surrounding air temperatures can result in
malfunction of the system.
ATTENTION: This product contains Electrostatic Discharge (ESD) sensitive
parts and assemblies. Static control precautions are required when you install
these assemblies. Component damage can result if ESD control procedures
are not followed. If you are not familiar with static control procedures,
reference any applicable ESD protection handbook.
ATTENTION: If you configure an analog input for 0…20 mA operation and
driving it from a voltage source could cause component damage. Verify
proper configuration prior to applying input signals.
At the end of its life, this equipment should be collected separately from any
unsorted municipal waste.
To Next Page
Loading...
