Rockwell Automation Allen-Bradley PowerFlex 755TS TotalFORCE Control - Terminal Block Specifications

64 Rockwell Automation Publication 750-IN119A-EN-P - April 2022
Chapter 5 Power Wiring
Terminal Block
Specifications
Table 7 - Frames 1…5 Power Terminal Block
Frame
Wire Size Range
(1) (2)
(1) Maximum/minimum wire sizes that the terminal block can accept. These sizes are not recommendations.
(2) Terminal blocks are designed to accept one wire.
Strip Length
[mm (in.)]
Recommended
Torque [N•m
(lb•in)]
Recommended Tools
Max
[mm
2
(AWG)]
Min
[mm
2
(AWG)]
1
4.0 (10) 0.2 (24) 8.0 (0.31) 0.57 (5.0) #2 Pozidriv, M3 x 7
2
3 16.0 (6) 0.5 (20) 10.0 (0.39) 1.2 (10.6) #2 flat screwdriver
4 35.0 (1) 2.5 (14) 10.0 (0.39) 2.7 (24.0)
#2 Pozidriv
492-C Phillips
0.25 in. flat screwdriver
5 35.0 (1) 10.0 (8) 12.0 (0.5) 4.0 (35.0)
#2 Pozidriv
492-C Phillips
0.25 in. flat screwdriver
Table 8 - Frames 6 and 7 Power Terminal Block
Frame
Maximum Lug
Width
(1)
[mm (in.)]
(1) Customers supply the lugs.
Recommended
Torque [N•m (lb•in)]
Terminal Bolt Size Recommended Tool
6 32.0 (1.26)
11.3 (100) M8 x 1.25 13 mm hex socket
743.5 (1.71)
Table 9 - Frames 1…7 PE Grounding Stud
Frame
Recommended Torque
N•m (lb•in)
Terminal Bolt/Screw Size Recommended Tool
11.36 (12) M4
T20 hexalobular (Torx)
#1 flat screwdriver
2 1.36 (12) M4 7 mm hex deep socket
3
3.4 (30) M6 10 mm hex deep socket4
5
6
11.3 (100) M8 13 mm hex socket
7