Rockwell Automation Publication 750-IN119A-EN-P - April 2022 17
Chapter 2
Receiving, Handling, and Storage
PowerFlex® 755TS frame 6 and frame 7 drives are bolted to wooden skids for
shipment. For ease of handling, Rockwell Automation recommends leaving the
products bolted to the skids until moved to the final installation area.
Receiving Standard packaged PowerFlex 755TS wall mount products are boxed and
shipped as a whole unit. Each unit is boxed or bolted to a shipping skid and is
covered with plastic wrap. Protection is not waterproof or watertight.
Heavy duty/export packaging is similar to standard packaging, but uses a
plastic wrap suitable for occasional light water-spray. In addition, wood
framing and sheeting surround the unit. Heavy duty/export packaging is not
waterproof, watertight, or intended for long-term storage.
Upon delivery of the PowerFlex 755TS product, refer to the packing slip for
sizes and exact shipping weights. The packing slip also lists the items that are
included in the shipment.
Inspect the shipment for damaged or lost items. If the packaging appears to be
damaged, unpack the equipment for further inspection. Remove covers and
inspect the major components for signs of damage. If there is evidence of
damage or loss, follow this procedure:
• Note on the delivery receipt that the equipment being received is
damaged.
• Contact the carrier that made the delivery and schedule an inspection.
• Inform your local Rockwell Automation representative that the
equipment is damaged.
• Retain all product packaging for review by the carrier.
For further assistance, contact your Rockwell Automation representative.
ATTENTION: To avoid personal injury or structural damage, never attempt to
lift or move products that weigh more than 18 kg (40 lbs.) by any means other
than the handling methods outlined in this publication.
ATTENTION: Exercise caution when moving the product to ensure the
equipment is not scratched, dented, or damaged in any manner.
To Next Page
Loading...
