Rockwell Automation Publication 750-IN119A-EN-P - April 2022 51
Chapter 4
Mechanical and Electrical Installation
The PowerFlex® 755TS installation process is divided into two principal tasks:
• Mechanically mount the enclosures
• Make power supply and motor connections (Chapter 5)
Installation of Products
with Corrosive Gas
Protection (XT)
PowerFlex 755TS products manufactured with XT use protective covers to help
seal connectors against environments with corrosive gases. To help provide
improved performance in these environments, only remove protective covers
to make a required connection. Do not remove protective covers from unused
connectors.
Access Panels, Covers, and
Doors
This section provides descriptions for how to remove and replace access
panels, covers, and doors on different drive sizes and enclosures.
Figure 30 -
Enclosure
Code R (IP20, NEMA/UL Open Type) Wall Mount, Frame 1
To Next Page
Loading...
