80 Rockwell Automation Publication 750-IN119A-EN-P - April 2022
Chapter 5 Power Wiring
Power Jumper Wire Location and Connection Options—Frame 1
Frame 1 products use jumper wires to complete an electrical connection when
installed. Install or remove jumper wires according to the recommendations in
Table 13
.
Figure 49 - Jumper Wire Positions—Frame 1
When jumper wires are Connected (In), press the spade connector firmly onto
the sheet metal tab.
ATTENTION: Hazard of equipment damage exists if jumpers aren’t properly
disconnected. For Frame 1, secure the disconnected jumper wire to the
insulated position provided.
Disconnected (Out)
Connected (In)
Disconnected (Out)
Connected (In)
To Next Page
Loading...
