ROEL CERBER C82 - Set of General System Options; Set of; Partition Options; Section [22] - 3 -Rd Set of General System Options

38
zone 4 LED
enabled
disabled
*
case tamper of keypad 4
zone 5 LED
enabled
disabled
*
tamper alarm activates siren when disarm
zone 6 LED
enabled
disabled
*
send periodical test only when armed
zone 7 LED
enabled
*
disabled
next trouble beeps stopping
zone 8 LED
enabled
disabled
*
warning on keypad’s buzzer when siren sounds
Note: The default programmed options are marked with *.
In order to activate / deactivate any of these options, press 1 to 8 keys. The
corresponding zone LED will turn ON / OFF accordingly.
If these options should keep their previously programmed values press [#] key instead of any
numerical key.
After establishing these options to the required values press [#] key to confirm. The
keypad buzzer will sound 6 beeps and exit this section, waiting for a new command to enter
another section or to exit the programming menu.
SECTION [22] – 3
-RD
SET OF GENERAL SYSTEM OPTIONS
While the system is within „main programming menu”, to establish the 3
-rd
set of General
System Options select section [22].
Once the panel entered section [22] the keypad buzzer will sound 3 confirmation beeps and
the panel will display the 3
-rd
set of General System Options, according to the table bellow:
Keypad LEDs’ status while the system is within 3
-rd
set of General System Options displaying
submenu
ARMED A LED
ON
ARMED B LED
OFF
SYSTEM LED
Blinking
READY A LED
ON
READY B LED
OFF
Zone LEDs
ON
OFF
OPTION
zone 1 LED
enabled
*
disabled
keypad 1 assigned to 1
-st
partition
zone 2 LED
enabled
*
disabled
keypad 2 assigned to 1
-st
partition
zone 3 LED
enabled
*
disabled
keypad 3 assigned to 1
-st
partition
zone 4 LED
enabled
*
disabled
keypad 4 assigned to 1
-st
partition
zone 5 LED
enabled
*
disabled
keypad 1 assigned to 2
-nd
partition
zone 6 LED
enabled
*
disabled
keypad 2 assigned to 2
-nd
partition
zone 7 LED
enabled
*
disabled
keypad 3 assigned to 2
-nd
partition
zone 8 LED
enabled
*
disabled
keypad 4 assigned to 2
-nd
partition
Note: The default programmed options are marked with *.
In order to activate / deactivate any of these options, press 1 to 8 keys. The
corresponding zone LED will turn ON / OFF accordingly.
If these options should keep their previously programmed values press [#] key instead of any
numerical key.
After establishing these options to the required values press [#] key to confirm. The
keypad buzzer will sound 6 beeps and exit this section, waiting for a new command to enter
another section or to exit the programming menu.
SECTION [23] – 1
-ST
SET OF 1
-ST
PARTITION OPTIONS
While the system is within „main programming menu”, to establish the 1
-st
set of 1
-st
Partition
Options select section [23].
Once the panel entered section [23] the keypad buzzer will sound 3 confirmation beeps and
the panel will display the 1
-st
set of 1
-st
Partition Options, according to the table bellow:
Keypad LEDs’ status while the system is within 1
-st
set of 1
-st
Partition Options displaying submenu
ARMED A LED
ON
ARMED B LED
OFF
SYSTEM LED
Blinking
READY A LED
ON
READY B LED
OFF
Zone LEDs
ON
OFF
zone 1 LED
enabled
disabled
*
quick arming