ROEL CERBER C82 - Partition Options

39
Keypad LEDs’ status while the system is within 1
-st
set of 1
-st
Partition Options displaying submenu
zone 2 LED
enabled
disabled
*
quick instant stay arming
zone 3 LED
enabled
disabled
*
quick stay arming
zone 4 LED
enabled
disabled
*
forced arming without codes
zone 5 LED
enabled
disabled
*
dings (1 ding upon arming, 3 dings upon disarming and 6 dings
upon disarming after alarms)
zone 6 LED
enabled
disabled
*
reserved
zone 7 LED
enabled
disabled
*
reserved
zone 8 LED
enabled
disabled
*
reserved
Note: The default programmed options are marked with *.
In order to activate / deactivate any of these options, press 1 to 8 keys. The
corresponding zone LED will turn ON / OFF accordingly.
If these options should keep their previously programmed values press [#] key instead of any
numerical key.
After establishing these options to the required values press [#] key to confirm. The
keypad buzzer will sound 6 beeps and exit this section, waiting for a new command to enter
another section or to exit the programming menu.
SECTION [24] – 1
-ST
SET OF 2
-ND
PARTITION OPTIONS
While the system is within „main programming menu”, to establish the 1
-st
set of 2
-nd
Partition
Options select section [24].
Once the panel entered section [24] the keypad buzzer will sound 3 confirmation beeps and
the panel will display the 1
-st
set of 2
-nd
Partition Options, according to the table bellow:
Keypad LEDs’ status while the system is within 1
-st
set of 2
-nd
Partition Options displaying submenu
ARMED A LED
ON
ARMED B LED
OFF
SYSTEM LED
Blinking
READY A LED
ON
READY B LED
OFF
Zone LEDs
ON
OFF
zone 1 LED
enabled
disabled
*
quick armings
zone 2 LED
enabled
disabled
*
quick instant stay armings
zone 3 LED
enabled
disabled
*
quick stay armings
zone 4 LED
enabled
disabled
*
forced arming without codes
zone 5 LED
enabled
disabled
*
dings (1 ding upon arming, 3 dings upon disarming and 6 dings
upon disarming after alarms)
zone 6 LED
enabled
disabled
*
reserved
zone 7 LED
enabled
disabled
*
reserved
zone 8 LED
enabled
disabled
*
reserved
Note: The default programmed options are marked with *.
In order to activate / deactivate any of these options, press 1 to 8 keys. The
corresponding zone LED will turn ON / OFF accordingly.
If these options should keep their previously programmed values press [#] key instead of any
numerical key.
After establishing these options to the required values press [#] key to confirm. The
keypad buzzer will sound 6 beeps and exit this section, waiting for a new command to enter
another section or to exit the programming menu.
SECTION [25] – 2
-ND
SET OF 1
-ST
PARTITION OPTIONS
While the system is within „main programming menu”, to establish the 2
-nd
set of 1
-st
Partition
Options select section [25].
Once the panel entered section [25] the keypad buzzer will sound 3 confirmation beeps and
the panel will display the 2
-nd
set of 1
-st
Partition Options, according to the table bellow:
Keypad LEDs’ status while the system is within 2
-nd
set of 1
-st
Partition Options displaying submenu
ARMED A LED
ON
ARMED B LED
OFF
SYSTEM LED
Blinking