Rohde & Schwarz FSP7 - Fig. 3-7 Removing the Front Module Controller

Module Replacement R&S FSP
1164.4556.82 3.16 E-1
Removing the Front Module Controller
 Unscrew the ten screws with washers of the front module controller board and take out the front
module controller as follows (see Fig. 3-17)
Note: The force to disconnect the controller connectors of the motherboard are very high.
The pulling of the controller to the front side will be done with the help of the slits at the
bottom side of the mounting plate.
Please push the board with a flat, blunt tool carefully and step by step to the front.
CAUTION
Do not insert the tool too deep in the slits and press only against the pc board !.
Pull out the board by pressing at alternate slits.
The board must not be bent!
Fig. 3-7 Removing the front module controller