Rohde & Schwarz FSP7 - Replacing the Labelling Panel on the Front Module

Module Replacement R&S FSP
1164.4556.82 3.26 E-1
Replacing the Labelling Panel on the Front Module
(See chapter 5, spare parts list, items 270 and 280, and explosion drawing 1093.4495.)
The labelling panel is the outer front panel which carries the labelling of all the parts on the front side of
the R&S FSP. Every model has its own labelling panel (270, 280, 290)
 Switch off the instrument and pull the mains plug.
 Unscrew the four screws (430) of the front handles on both sides and take off the front handles.
 Remove the volume control knob (Option R&S FSP-B3), if present, by pulling it off.
 Pull off the labelling panel (270) towards the front.
 Install the New labelling panel and tighten all screws.
 Complete the instrument.
 Connect the instrument to the mains, switch on the instrument power switch and switch on the
instrument with the ON/STANDBY key