Rohde & Schwarz FSP7 - Replacing the Battery Charger Module (Option R&S FSP-B31;32)

R&S FSP Module Replacement
1164.4556.82 3.67 E-1
Replacing the Battery Charger Module (Option R&S FSP-B31/32)
Opening the Battery Pack and Removing the Module
 Remove the battery pack from the instrument.
 Undo the three screws (1) on the bottom.
 Pull out the cover (2) to the rear.
 Unplug all cables.
 Undo the two screws on the jack (5) and pull out the jack (5).
 Undo six screws (6) and remove the battery charger module (3030).
Installing the Battery Charger Module and Completing the Instrument
 Install new battery charger module (3030) and refasten with six screws (6).
 Install jack (5), fasten with two screws and reconnect all cables.
 Replace the cover (2), pressing the batteries down and making sure that no cables are trapped.
 Refasten the cover with three screws (1).
Fig. 3-2 Removing and installing the battery charger module, R&S FSP-B31/32