Rohde & Schwarz FSP7 - Checking Noise Display

Performance Test R&S FSP
1164.4556.82 1.10 E-1
Checking Noise Display
Test equipment:
50  termination (refer to "Measurement Equipment", item 7)
Frequency range R&S FSP 3: to 3 GHz
R&S FSP 7: to 7 GHz
R&S FSP 13: to 13.6 GHz
R&S FSP 30: to 30 GHz
R&S FSP 40: to 40 GHz
Test setup:
 Terminate the RF input of the R&S FSP with 50 .
R&S FSP settings:
- [ PRESET ]
- [ AMPT : RF ATTEN MANUAL : 0 dB ]
- [ SPAN : 0 Hz ]
- [ BW: RES BW MANUAL : 10 Hz ]
- [ BW : VIDEO BW MANUAL : 1 Hz ]
- [ BW : SWEEP TIME MANUAL : 0.1 s ]
- [ TRACE 1 : AVERAGE ]
- [ TRACE 1 : SWEEP COUNT : 30 ENTER ]
- [ AMPT : {RefLev} ]
- [ FREQ : CENTER : {f
n
} ]
Refer to table below for values of RefLev.
Refer to "Performance Test Report" table for values of f
n
.
Measurement:
 Set marker to peak:
- [ MKR  : PEAK ]
Evaluation:
The noise level is displayed by the level reading of marker 1.
Frequency
< 10 kHz < 100 kHz < 1 MHz < 10 MHz > 10 kHz
RefLev
-10 dBm -20 dBm -30 dBm -60 dBm -60 dBm