Rohde & Schwarz R&S SMA100A - Page 14

R&S SMA100A Information on the Current Version and History
Release Notes for Firmware 1171.5360.52 14
● Annotation of Frequency and Level displays can be disabled and enabled in SETUP
Security
● Display can be deactivated to hide instrument settings. Configuration in SETUP
Security or by SYSTem:DLOCk ON|OFF.
● Keyboard can be deactivated to prevent unauthorized modification of instrument
settings. Configuration in SETUP Security or by SYSTem:KLOCk ON|OFF
Modified Functionality
● RF leakage improved if RF OFF
● NRP-Z Power Viewer will be switch on by default if a power sensor is plugged in
● Support of up to four power sensors in Power Viewer and Power Analysis. New
SETUP NRP-Z Info dialog provides properties of all power sensors connected. In
addition, sensor firmware can be updated via instrument.
● Level unit is preserved during power off
● All sweeps: Maximum dwell time increased to 100s
● Revised and simplified configuration of emulation settings in Remote Channel
Settings dialog.
● External USB keyboards: Support of international keyboard layouts
● Revised and simplified network settings dialog including connection state indicator.
Option “Peer to Peer” removed since this feature is covered by the “Auto(DHCP)”
mode now.
● Improved Security concept (menu SETUP Security Settings)
● Improved file selector and file manager
● To avoid unintentional instrument settings, values entered by keyboard or front
panel will be discarded when input is aborted without confirmation by ENTER or unit
key
● OCXO Adjustment: Calibration value is not affected by PRESET or *RST
● Remote control emulation HP 8643: FMpreemphasis and LFSource:xyz2
implemented
● Improved firmware update process in case of less free flash memory
Fixed Issues
● Option R&S® SMA-K27 (Pulse Train): Repetition count does not work for last table
entry in trigger mode “Ext Triggered”
● SCPI command SENS:POW:SOUR returns RF instead of “A”
● SCPI command CORR:CSET:DATA:SEND:POW:SONC does not work
● AM Modulation: For frequencies <= 30 MHz the error message “Level Overrange”
appears