R&S SMA100A Information on the Current Version and History
Release Notes for Firmware 1171.5360.52 7
o Right Frequency 0.5 Hz → 0.05 Hz
o COM/ID Frequency 0.1 Hz → 0.01 Hz
MKR-BNC Modulation (R&S® SMA-K25): The resolution for the following
parameters are increased:
o COM/ID Frequency 0.1 Hz → 0.01 Hz
ADF Modulation (R&S® SMA-K25): The resolution for the following parameters are
increased:
o COM/ID Frequency 0.1 Hz → 0.01 Hz
Fixed Issues
Remote control emulation for AF203x / AF204x / AF205x: The preset behavior
depends on the installed options.
1.4 Version 3.01.102.17
Released: February 2014
New Functionality
● Level Settings: Added new parameter “Ignore Level Range Warnings”. If it is active
the following warnings will be suppressed:
– -221,"Settings conflict;Level Overrange"
– -221,"Settings conflict;Level Underrange"
– -221,"Settings conflict;PEP value greater than defined upper bound (fix range)"
– -221,"Settings conflict;PEP value less than defined lower bound (fix range)"
Modified Functionality
● VOR Modulation (R&S® SMA-K25): For the SCPI command
[:SOURce]:VOR:ICAO:CHANnel the selection of ICAO channels are changed from
the notation <ChannelSuffix><ChannelNumber> to
CH<ChannelNumber><ChannelSuffix>.
The old notation works furthermore for set commands.
For example:
[:SOURce]:VOR:ICAO:CHANnel CH17X
● DME Modulation (R&S® SMA-K26) : For the SCPI command
[:SOURce]:DME:ICAO:CHANnel the selection of ICAO channels are changed from
the notation the notation <ChannelSuffix><ChannelNumber> to
CH<ChannelNumber><ChannelSuffix>.
The old notation works furthermore for set commands.
For example:
[:SOURce]:VOR:DME:CHANnel CH17X
To Next Page
Loading...
