R&S SMA100A Information on the Current Version and History
Release Notes for Firmware 1171.5360.52 18
● New feature remote control emulation HP 8664/8665
Modified Functionality
● ILS-GS and ILS-LOC: New parameter DDM Polarity. In the default state this value
is 90 Hz – 150 Hz
● All avionics modulation (Options R&S® SMA-K25 and R&S® SMA-K26):
Enhanced COM/ID settings, with the possibility to set individual dot, dash, symbol
space and letter space length.
● NRP-Z Power Viewer: Support of up to three R&S NRP-Zxx power sensors. The
different R&S NRP-Zxx power sensors can be selected via a combobox at the top
of the dialog NRP-Z Power Viewer.
● The summary screen (large frequency and level display) can be activated and
deactivated in the menu Setup → Display Settings. In the default state the
summary screen is deactivated. This setting is not affected by pressing the
PRESET button or sending *RST.
● The RF output can be deactivated, if the reference oscillator source is set to
external and no reference signal is connected. In this case the RF output can be
deactivate in the menu RF → Ref Oscillator. In the default state the RF output is
not deactivated. This setting is not affected by pressing the PRESET button or
sending *RST.
Fixed Issues
● LF Output: The LF generator frequency differs for more than 5 mHz
● Dialog of the online help window too large
● Adjustment: If the internal adjustments are executed with external reference, and
no external reference is connected, no error message occurs. Phase continuous
frequency settings: In rare cases the frequency synthesis could be work in an
undefined state. Only with R&S SMA-B20
● ILS-GS and ILS-LOC: Improvements for DMM input in µA
● Remote control emulation: No remote sign in emulation mode
● Remote control emulation Aeroflex 203x/4x: The command MODE does not work
1.21 Version 2.05.68.18
Released: July 2008
Fixed Issues
● External Pulse Modulation: Unwanted double pulse at rising pulse edge
To Next Page
Loading...
