56
Using Insert Effects
5
If you want to save the current effect settings, proceed
as described in “Saving the Insert Effect Settings
(Write)” (p. 57).
To create a new effect sound, choose an existing patch that’s
close to what you have in mind, and then edit it. When
saving the edited patch, save it as a user patch or song patch.
1
Press the [EFFECTS] button.
The EFFECT screen will appear.
2
Select an effect patch.
Use the CURSOR buttons and dial to select the bank,
preset/song/user, and number.
3
Use the CURSOR [ ] [ ] buttons to move the
cursor to “PATCH,” and press the [ENTER] button.
The effect edit screen will appear, and the algorithm
(the available effects and their connection order) will
be displayed.
D_Effect_Edit.eps
The effect settings you edit are temporary. If you
exit the effect edit screen without saving the edited
effect patch, an “*” is displayed in front of the patch
name. If you select a different effect patch when this
“*” indication is shown, the edited effect patch will
revert to its original state, and the changes you
made will be lost.
Editing the Insert Effect
Settings
If there’s a specific effect that you want to use, you
should choose a patch whose algorithm includes
that effect.
The available effects differ for each algorithm. For
details on the effects for each algorithm, refer to
“Algorithm List” (p. 59).
P: preset / S: song / U: user
Number
Bank
Patch name
Algorithm name
BR800_e.book 56 ページ ２０１０年３月２日 火曜日 午後６時４０分
To Next Page
Loading...
