MODULATION
BENDER
FUNC
CONTROL TRANSPOSE
ZONETX CH
DEPTH
TIME
CONTROL
RX CH
TRANSPOSE
ZONE
KEY TOUCH
TREMOLO
ATTACK
INDICATOR
VELO SENSE
DECAY
LOCAL
BEND DOWN
RELEASE
BULK
BEND UP
BRIGHT
ENTER
A/B
0
7
4
1
8
5
2
9
6
3
DETUNE PITCH
SPLIT
BANK M PGM C
TRANSPOSE DEC INC
CHORUS
LOWER
DUAL SPLIT
UPPER
EQUALIZER
TX CONTROL
MAX
MIN
MAX
MIN
MAX
MIN
REVERB
LEVEL VARIATION
FLAT
BANK L
SYNTH STRINGS
INTERNAL CONTROL
HARPSI ORGAN
CLAVI/
RHODES E.PIANO
E.GRAND
MKS
-
20
GRAND 1 GRAND 2
BASS
PERCUSSION
56
3412
CDB
78
SETUP MEMORY
NUMBER
NUMBER
EQUALIZER
LOWER UPPER
BOOST
CUT
BOOST
CUT
BOOST
CUT
FLAT FLAT
C1
A
TUNE
WRITE
YES NO
PANIC
DEMO
INT
VOLUME LOW MID HIGH
VALUE
GROUP
LOWER UPPER
TX
TX/INT LEVEL
INPUT 1(XLR/TRS)
INPUT 2-6
* A "Blank User Settings Chart" can be found on p. 24. Use this chart to record
connections to other equipment, knob positions, and other settings.
Electronic Musical Instruments (XP-60, RD-500, etc.)
Recording Equipment (Tape Recorder, DAT, etc)
Equalizer, etc.
CD Player
Stereo Headphones
(RH-120, etc.)
Effects Processor (SE-70, etc.)
Speaker System (SST-151, etc.)
INPUT 7-8
RETURN
SEND
REC OUT
MIXER OUT
AMP IN
INPUT 9-10
PHONES
Microphone (DR-10/20, etc.)
Basic Connections
NOTE
NOTE
However, be sure only to connect cables specifical-
ly made for use with speakers. Use of cables (such
as shielded cables) that accumulate significant stat-
ic electricity can cause power amp overload, over-
heating, and damage to the equipment; do not use
such cables.
The binding post speaker terminals can be made
using banana plugs and large-diameter speaker ca-
ble.
When Applying the Anti Feed-
back Function:
Connect mics to Channels 1–6,
and other devices (electronic in-
struments, CD players, and oth-
er such devices) to Channels 7-8
and 9-10.
MEMO
To prevent malfunction and/or damage to speakers or other
devices,always turn down the volume, and turn off the pow-
er on all devices before making any connections.
To Next Page
Loading...
