Mode 2 Musical data update by means of the USB:
1. Format the built-in memory of the E-50
- Turn on the instrument.
- Press the switch “DISK & MEDIA” on the display.
- Press the button “FORMAT” on the display.
- Press the button “EXTERNAL MEMORY” on the display. Wait until the formatting is completed.
2. Copy the musical data into the built-in memory
- Connect the E-50 to the PC by means of a USB cable.
- Press the switch MENU on the panel.
- Press the button “USB DATA STORAGE” on the display.
- Press the button “INTERNAL MEMORY” on the display. A new virtual drive “E50_SSD” will be added on the computer resources.
- Decompress the files container in the data update zip (E50_Factory_Data_Vxxx.zip) into a temporary file of the PC called for instance “E-50”.
- Open the file previously created in the PC called “E-50” containing the data.
- Copy, by selecting and moving all the files of the PC into the new virtual drive “E50_SSD”.
- ATTENTION ,
before removing the USB cable and turning the instrument off, disconnect the virtual drive E50 SSD from the PC
by means of a proper function.
THE FAILURE TO DISCONNECT MAY CAUSE THE COPY OF THE FILES TO BE INCOMPLETE.
3. Carry out the Factory Reset
- Turn on the instrument.
- Press the switch MENU on the panel.
- Press the button “UTILITY on the display
- Press the button “FACTORY RESET” on the display
- Press the button “EXECUTE” on the display and wait until the operation is completed.
Update of the operative system
There are 3 ways to update the Operative System of the E-50.
Mode 1:
By means of a Card.
- It is made by means of a Card (compact flash, smart media, memory stick …) of at least 64 Mbytes and a PCMCIA adaptor for that card.
Mode 2:
By means of a USB connection.
- It is made by means of a connection USB PC => E-50.
To Next Page
Loading...
