Mode 1 Update of the Operative System by means of a card:
1. Format a card with a E-50
- Turn on the instrument.
- Insert one Card (min. 64MB) by means of the relative PCMCIA adaptor into the PCMCIA slot of the E-50.
- Press the switch “DISK & MEDIA” on the display.
- Press the button “FORMAT” on the display.
- Press the button “EXTERNAL MEMORY” on the display. Wait until the formatting is completed.
2. Copy the operative system into the “UPDATE” directory of the Card
- Insert the card into a PC with the relative adaptor.
- Delete a possible previous operative system from the “UPDATE” directory of the card.
- Decompress the files container in the zip updating file (E50_Vxxx.zip), into a temporary card of the PC.
- Open the file previously created in the PC containing the operating system.
- Copy, by selecting and moving the .sys file (E50_VER_x_x_x. .sys) of the operative system from the PC into the “UPDATE” directory of the Card.
ATTENTION ,
before removing the card, disconnect the drive of the card from the PC by means of a proper function.
THE FAILURE TO DISCONNECT MAY CAUSE THE COPY OF THE FILES TO BE INCOMPLETE.
3. Update of the operative system.
- Insert the card into the PCMCIA slot of the E-50 by means of an adaptor.
- Turn on the instrument by holding the “DISK & MEDIA” switch on the panel.
- Wait until the instrument shows the “SYSTEM UPDATE” video.
- Press the “8BEAT 16BEAT” switch on the panel, STYLE section.
- The E-50 will carry out a deep check of the system, if the file will turn out to be correct, it will start the update phase.
A progression bar will show the status of the updating.
4. Carry out the Factory Reset
- Turn on the instrument.
- Press the “MENU” switch on the panel.
- Press the “UTILITY” button on the display.
- Press the “FACTORY RESET” button on the display.
- Press the “EXECUTE” button on the display and wait until the operation is completed.
Mode 2 Operative System Update by means of a USB
:
1. Copy the operative system into the “UPDATE” directory of the built-in memory
- Connect the E-50 to the PC by means of a USB cable.
- Press the “MENU” switch on the panel.
- Press the “USB DATA STORAGE” button on the display.
To Next Page
Loading...
