Roland E-A7 - Optimizing the Acoustic Character for the Internal Speakers; Demo of the E-A7; Making the Power Automatically Turn off after a Time (Auto Off)

13
Before You Start Using E-A7
Optimizing the Acoustic Character for the
Internal Speakers
If you turn on the [Output Mode] button, the output sound is
adjusted optimally for the response of the E-A7’s built-in speakers.
1. Press the [Output Mode] button to make it light.
MEMO
You can specify whether the [Output Mode] button will be on or
o when the E-A7 starts.
&
“Reference Manual” (PDF)
2. To turn the [Output Mode] button o, press the [Output
Mode] button once again (the button goes dark).
The Mastering Tools’ Equalizer and Compressor settings will be
enabled.
MEMO
With the factory settings, Mastering Tools’ Type is set to
“Standard.” The Type “Standard” settings are optimal when
connecting the Phones/Output jacks to external speakers or a PA
system.
You can also change the settings that are used when the [Output
Mode] button is o.
&
“Reference Manual” (PDF)
0
“Mastering Tools Function”
Demo of the E-A7
Your E-A7 contains a demo that introduces all of its highlights. It
might be a good idea to try it out now. The demo is self-explanatory,
so we’ll just show you how to start and stop it.
1. Press the [Favorite] button and [Menu] button
simultaneously.
Playback starts automatically with the demo song.
2. Press the [Exit] button to leave the demo function.
NOTE
5 No data for the music that is played will be output from the
MIDI OUT connector and the USB COMPUTER port.
5 All rights reserved. Unauthorized use of this material for
purposes other than private, personal enjoyment is a violation
of applicable laws.
Making the Power Automatically Turn O
After a Time (Auto O)
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (factory
setting).
If you don’t need the power to turn o automatically, set “Auto O”
to the “OFF” setting as described below.
1. Press the [Menu] button to make it light.
The Menu screen appears.
2. Use the direct buttons to select “Global.”
3. Use the function buttons to move the pages.
4. Use the direct buttons to select “Auto O.”
5. Use the Value [-] [+] buttons to select “OFF.”
6. Press the [Exit] button to return to the previous screen.
MEMO
The settings are automatically saved in the Global parameters
when you exit the screen.