Important Notes on Handling and Use
This machine is a precision device. To ensure the full performance of this machine, be sure to observe the
following important points. Failure to observe these may not only result in loss of performance, but may
also cause malfunction or breakdown.
This machine is a precision device.
Handle carefully, and never subject the machine to impact or excessive force.
Diligently keep clean of cutting waste.
Use within the range of specications.
Never attempt to move the tool carriage by hand with undue force.
Never needlessly touch anywhere inside the machine except for locations specied in this manual.
Install in a suitable location.
Install in a location that meets the specied conditions for temperature, relative humidity, and the
like.
Install in a quiet, stable location offering good operating conditions.
Never install in out of doors.
Never use the machine in an environment where silicone substances (oil, grease, spray, etc.) are
present. Doing so may cause poor switch contact.
This machine becomes hot.
Never cover the ventilation holes with cloth, tape, or anything else.
Install in a well-ventilated location.
About Tools
Use a cutter that is suitable for the workpiece and the cutting method.
The tip of the tool is breakable. Handle with care, being careful not to drop it.
9
To Next Page
Loading...
Need help?
General
