4-1 Maintenance
41
Chapter 4 Appendix
Replacing the Bearing for the Depth Regulator Nose
When engraving is performed, cuttings may get inside the bearing, resulting in a strange noise.
Because this can also degrade the quality of engraving, replacement of the bearing after every 100 hours of engraving is
recommended.
Replacement of Spindle Belt
Please be aware that the replacement of spindle belt is charged, even when performed within the unit's
warranty period.
The belt is a part that wears out.
As a guideline, the spindle belt should be replaced after every 2000 hours of use.
How to Remove the Bearing
How to Install the Bearing
Bearing for depth
regulator nose
3 mm (1/8 in.)
Screw on the bearing for the
depth regulator nose until
this space is approximately
3 mm (1/8 in.).
To Next Page
Loading...
