Unpacking
Retaining materials are attached to protect the machine from vibration during shipment. When installation is complete,
remove these and store in the specied locations.
Remove all retaining materials. Any that remain may cause faulty operation or breakdown when the power is switched
on.
The retaining materials are required when moving the machine to a dierent location. Store them carefully so that they
do not get misplaced.
WARNING
Carry out these operations before you connect the power cord.
Inadvertent powerup may result in pinched hands or other injury.
Removing the retainers
Make sure the power cord is
not connected, then remove
retainers A, B, and C.
To Next Page
Loading...
