1-2 Part Names and Functions
Front
Rear
Tool mounting screw
This secures the depth regulator
nose or tool adapter in place.
Vacuum-adapter hose port
This is where the dust col-
lector is attached to take up
cuttings while engraving is
in progress.
Control Panel
(Described on the
following page.)
Table
The workpiece to be
engraved is mounted
on this.
Tool carriage
Serial connector
This is for connecting a serial (RS-232C
compliant) cable.
P. 21, “Connecting to the Computer”
Power-cord connector USB connector
This is for connecting a
USB cable.
P. 21, “Connecting to the
Computer”
To Next Page
Loading...
