Connecting to the Computer
USB cable
You use a USB cable to connect the machine and the computer. At this time, however, the connection to the computer must
not be made yet. You make the connection to the computer when you install the Windows-based driver.
P. 23 "Installing the Windows-based Driver"
Be sure to make the connection according to the instructions on page 23, "Installing the Windows-based Driver." Making
the connection without doing so may cause driver installation to fail and make use impossible.
Never connect two or more machines of this model to a single computer.
For the USB cable, use the included cable.
Never use a USB hub.
Serial cable
Using a serial cable requires making the settings for the communication parameters with the computer. For the serial cable,
use a separately available XY-RS-34 from Roland DG Corp.
At this time, keep the
cable unconnected .
USB cable
Computer
USB port
Serial cable
Computer
Secure in place with the screws.
RS-232C connector
2-3 Cable Connections
21
Chapter 2 Installation and Setup
To Next Page
Loading...
