Roland EGX-30A - Control Panel

Control Panel
rpm knob
This sets the spindle
speed (in rpm).
SPEED knob
This sets the cutting
speed.
SELECT key
This selects the cutting mode. The LED
for the selected mode lights up.
SET SURFACE / TEST key
Pressed briey: When the character cutter has been in-
stalled, this moves the tool up or down.
Held down for one second or longer: Performs test cutting.
PAUSE / VIEW key
Pressed briey: Pauses operation.
Held down for two seconds or longer: Moves the tool
carriage to the rear right (the VIEW position) and pauses
operation.
The functions of these keys differ
depending on whether the key is
pressed briey and immediately
released or held down for a cer-
tain length of time.
ORIGIN POINT / SET ORIGIN POINT key
Pressed briey: Moves the tool carriage to the origin point.
Held down for two seconds or longer: Makes the present
position of the tool carriage the origin point.
Held
down
Pressed
briey
ARROW keys
These are used to move the tool carriage in the direction
of the arrow. Hold down the key for faster movement.
14 Chapter 1 Getting Started
1-2 Part Names and Functions