2-2 Installation
Installation Environment
Install in a quiet, stable location oering good operating conditions. An unsuitable location can cause accident, re, faulty
operation, or breakdown.
WARNING
Install in a location that is level and stable.
Installation in an unsuitable location may cause an accident, including a fall or
tipover.
WARNING
Never install in a location exposed to open ame.
Cutting waste may ignite. Powdered material is extremely ammable, and even
metal material may catch re.
WARNING
Never install close to any ammable object or in a gas-lled location.
Combustion or explosion may be a danger.
WARNING
Never install outdoors or in any location where exposure to water or high humidity
may occur.
Doing so may result in re or electrical shock.
WARNING
Position so that the power plug is within immediate reach at all times.
This is to enable quick disconnection of the power plug in the event of an emergency.
Install the machine next to an electrical outlet. Also, provide enough empty space
to allow immediate access to the electrical outlet.
Never install in a location subject to wide uctuations in temperature or humidity.
Never install in a location subject to shaking or vibration.
Never install in a location where the oor is tilted, not level, or unstable.
Never install in a dusty or dirty location, or outdoors.
Never install in a location exposed to direct sunlight or near air-conditioning or heating equipment.
Never install in a location exposed to considerable electrical or magnetic noise, or other forms of electromagnetic en-
ergy.
Never install in an environment where silicone substances (oil, grease, spray, etc.) are present.
To Next Page
Loading...
