Roland GRAND - Connecting the Power Cord; Turning the Power On;Off

18
Getting Ready
1.
Connect the pedal cord to the Pedal connector of the jack panel located on the bottom left of the piano.
2.
Connect the power cord to the AC in of the jack panel.
3.
Connect the power cord to an electrical outlet.
941
Once the connections have been completed (p. 18), turn on power to your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
943
Before switching the power on/off, always be sure to turn the volume down. Even with the volume turned down, you might hear
some sound when switching the power on/off. However, this is normal and does not indicate a malfunction.
Turning the power on
1.
Turn the [Volume] knob all the way to the left.
2.
Press the [Power] switch.
After a short while, sound will be heard when you play the keyboard. Use the [Volume] knob to adjust the volume.
942
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will
operate normally.
Connecting the Power Cord
Turning the Power On/Off
Jack panel 1
Power cord
(included)
V-Piano-Grand_e.book 18 ページ ２０１１年２月１０日 木曜日 午後１２時４分