Roland GRAND - Using the Pedals to Control the V-Piano Grands Functions

39
Playing
You can assign various functions to a pedal, and use the pedal to control the V-Piano Grand.
You can assign functions to the left pedal and the center pedal.
The right pedal always functions as a damper pedal. No other function can be assigned to it.
Parameters for which a check mark appears in the “Together with another function” column allow two functions to be
simultaneously assigned to a single pedal.
SETUP UP and SETUP DOWN can be selected only if the pedal settings are the settings stored in system memory.
The “Abbreviation in the tone screen” will be displayed when PEDAL has been set for “Information Type” (p. 59).
Using the Pedals to Control the V-Piano Grand’s Functions
Functions That Can Be Assigned to a Pedal
Function
Value
Together with
another function
Abbreviation in
the tone screen
Remarks
Operate as soft pedal
SOFT
✔ Soft
Operate as sostenuto pedal SOSTENUTO
✔ Sosten
Turn on/off MIDI output of
performance data
MIDI OUT SW M.Out
Play/stop the selected song SONG PLAY/STOP PlayST
Turn transpose on/off TRANSPOSE SW Trans Linked with the [Transpose] button.
Move the playback position to the
beginning of the song
SONG RESET Reset
Adjust the volume of the entire
V-Piano Grand
MASTER VOLUME
✔ Volume
Linked with the utility screen’s
“1. System–Master Volume.”
The V-Piano Grand’s volume EXPRESSION
✔ Expres
Adjust the ambience AMBIENCE LEVEL
✔ AmbLvl
Linked with the [Ambience] knob.
Adjust the tone parameter
SOUND LIFT
✔ S.Lift
STRING RESONANCE
✔ S.Reso
DAMPER RESONANCE ✔ D.Reso
SOUNDBOARD RESO
✔ Sndbd
The name of the tone parameter is
“Soundboard Resonance”
KEY OFF RESONANCE
✔ K.Reso
UNISON TUNE
✔ Tuning
HAMMER HARDNESS
✔ Hammer
CROSS RESONANCE ✔ C.Reso
DECAY TIME
✔ Decay
TONE COLOR
✔ TColor
DAMPING TIME
✔ D.Time
DAMPER NOISE LEVEL
✔ D.Nois
Recall the next setup SETUP UP SUP.Up
Recall the preceding setup SETUP DOWN SUP.Dn
V-Piano-Grand_e.book 39 ページ ２０１１年２月１０日 木曜日 午後１２時４分