4-1 Practicing Cutting Using the Test-use Material
Chapter 4: Performing Cutting
44
Moving the Cutting Carriage
Pressing moves the cutting carriage, and pressing
moves the material.
When you want to adjust the position a little at a time, press the
key repeatedly, holding it down for only a short time with each
press.
To move continuously for a long distance, hold down the key.
When you press and hold down the key, movement proceeds slowly
for the first 20 millimeters of movement distance.
When the movement distances exceeds 20 millimeters, movement
speeds up.
➊
Hold down until the material reaches the location
where its movement stops.
The material moves toward the rear.
➋
Use to move the cutting carriage to the location
where the cutting test can be performed.
Position at a location away from where you peeled off the material
earlier.
Now you're ready to perform a cutting test again. Carry out the cutting test and check the cutting quality for the
material.
☞
p 42 "Performing a Cutting Test"
Repeat the procedure described above until the test results are acceptable.
When you obtain acceptable results, go on to "Step 4: Set the Origin Point."
☞
p 45 "Step 4: Set the Origin Point"
Move slowly Move rapidly
To Next Page
Loading...
