How to increase the volume of a device connected to my Roland JUNO-Gi?
If the volume from a device connected to your Roland Synthesizer is insufficient, use a connection cable that does not contain a resistor. Also, adjust the volume of your external device to an appropriate level, and adjust the INPUT [LEVEL] knob.
Why is there no sound from the microphone on my Roland JUNO-Gi?
If you are experiencing no sound or insufficient sound from the microphone on your Roland Synthesizer, check the microphone cable connection. If you're using a condenser microphone, set the phantom power supply appropriately. Check the rear panel MIC IN [LEVEL] knob and turn on the AUDIO INPUT SELECT setting.
How to hear the input source on my Roland JUNO-Gi?
If you're not hearing the input source on your Roland Synthesizer, adjust the INPUT [LEVEL] knob. Also, adjust the Level value on the INPUT screen. Finally, ensure that the AUDIO INPUT SELECT setting is turned on.
Why is there no sound from a specific track on my Roland JUNO-Gi?
If you're not getting any sound from a specific track on your Roland Synthesizer, try raising the volume level (Track Level parameter). Also, ensure that the V-track setting has selected the correct V-track that contains data.
Why is the pitch wrong on my Roland JUNO-Gi Synthesizer?
If the pitch of your Roland Synthesizer sounds wrong, here are a few things to check: * Verify the system setting “Master Tune”. * Check the pedal and the pitch bender, as the pitch could have been changed by a pedal operation or by a pitch bend message received from an external MIDI device. * Check the settings of the Coarse and Fine parameters, as you may have edited the coarse tune or fine tune settings of a specific Layer.
How to fix sound distortion on Roland JUNO-Gi Synthesizer?
If you're experiencing sound distortion with your Roland Synthesizer, here's what you can do: * If a specific Live Set or Layer sounds distorted, try lowering the volume of that Live Set or Layer. * If the overall sound is distorted, lower the [VOLUME] knob. * Check the system setting “SOUND” to ensure the Output Gain isn't raised excessively.
What to do if my Roland JUNO-Gi power won't turn on?
If your Roland Synthesizer isn't turning on, here are a few things you can check: 1. Make sure that the included AC adapter and power cord are correctly connected. Using any AC adapter or power cord other than the supplied items can cause malfunctions. 2. Check the remaining battery power. 3. Open the battery case and make sure that the batteries are installed in the correct polarity.
General| Polyphony | 128 voices |
|---|---|
| Parts | 16 parts |
| Keyboard | 61 keys (with velocity) |
| Wave Memory | 128 MB (16-bit linear equivalent) |
| D Beam Controller | Yes |
| Power Supply | AC Adaptor |
| Effects | Multi-effects, reverb, chorus |
| Display | 240 x 64 dots graphic LCD |
| Sequencer | 16-track sequencer |
| Outputs | 2 x 1/4" (L/Mono, R), 1 x 1/4" (phones) |
| USB | USB (audio/MIDI/data transfer) |
| Preset Patches | Over 1, 300 |
| External Storage | SD/SDHC memory card |
| Connectors | MIDI In/Out, USB |
| Weight | 5.7 kg |
| Patches | Preset: 1, 000 + User: 256 |
| Sampling | Not supported |
To Next Page
