Roland Juno-Stage - TVF ENVELOPE

107
Chapter 8. Detailed Editing for Patches
TVF ENVELOPE
Parameters indicated by ( ) can be edited via ZOOM EDIT (p. 94).
Parameter marked with a “ ★ ” can be controlled using specified MIDI messages.
(Matrix Control, p. 110)
Parameter
Value Explanation
Cutoff V-Curve
FIX, 1–7
Curve that determines how keyboard playing dynamics (velocity) will affect the cutoff frequency
Set this to “FIX” if you don’t want the Cutoff frequency to be affected by the keyboard velocity.
Cutoff V-Sens -63–+63
Use this parameter when changing the cutoff frequency to be applied as a result of changes in playing
velocity.
If you want strongly played notes to raise the cutoff frequency, set this parameter to positive (+) settings.
Resonance V-Sens -63–+63
This allows keyboard velocity to modify the amount of Resonance.
If you want strongly played notes to have a greater Resonance effect, set this parameter to positive (+) settings.
F-Env V-Curve FIX, 1–7
Curve that determines how keyboard playing dynamics (velocity) will affect the TVF envelope
Set this to “FIX” if you don’t want the TVF Envelope to be affected by the keyboard velocity.
F-Env V-Sens -63–+63
Specifies how keyboard playing dynamics will affect the depth of the TVF envelope.
Positive (+) settings will cause the TVF envelope to have a greater effect for strongly played notes, and
negative (-) settings will cause the effect to be less.
F-Env T1 V-Sens -63–+63
This allows keyboard dynamics to affect the T1 of the TVF envelope.
If you want T1 to be speeded up for strongly played notes, set this parameter to a positive (+) value.
F-Env T4 V-Sens -63–+63
Use this parameter when you want key release speed to affect the T4 value of the TVF envelope.
If you want T4 to be speeded up for quickly released notes, set this parameter to a positive (+) value.
Parameter
Value Explanation
F-Env Depth
Env Depth
-63–+63
Depth of the TVF envelope
Higher settings will cause the TVF envelope to produce greater change. Negative (-) settings will invert
the shape of the envelope.
F-Env Time KF
(Time Keyfollow)
-100–+100
Use this setting if you want the TVF envelope times (T2–T4) to be affected by the keyboard location.
Based on the TVF envelope times for the C4 key (center C), positive (+) settings will cause notes higher
than C4 to have increasingly shorter times.
F-Env Time 1–4 ★
Time 1–4
0–127
TVF envelope times (T1–T4)
Higher settings will lengthen the time until the next cutoff frequency level is reached.
F-Env Level 0–4
Level 0–4
0–127
TVF envelope levels (L0–L4)
Specify how the cutoff frequency will change at each point, relative to the Cutoff Frequency value.
1234567
1234567
ZOOM
ZOOM
ZOOM
ZOOM
T1 T2 T3 T4
L3
L1
L0
L2 L4
Note off
Cutoff
Frequency
TVF Envelope
Time
Note on
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
Time Keyfollow
JUNO-STAGE_e.book 107 ページ ２００８年１０月１７日 金曜日 午後１２時２７分