Roland Juno-Stage - Specifying How Multi-Effects are Combined (MFX STRUCTURE); Chorus Settings (CHORUS); Reverb Settings (REVERB)

86
Chapter 5. Applying Effects to the Sound
Here you can specify how MFX 1–3 will be combined.
This parameter does not exist in Patch mode.
fig.
In the MFX screen (p. 84) or MFX CTRL screen (p. 84), press [5 (STRUCT)] to access
the MFX STRUCTURE screen.
Use the cursor buttons to move the cursor to the parameter that you want to edit, and
use the VALUE dial or [DEC] [INC] to set the value.
fig.
From the EFFECT ROUTING screen (p. 80, p. 82), press [4 (CHORUS)] to access the
CHORUS screen.
Use the cursor buttons to move the cursor to the parameter that you want to edit, and
use the VALUE dial or [DEC] [INC] to set the value.
From the EFFECT ROUTING screen (p. 80, p. 82), press [5 (REVERB)] to access the
REVERB screen.
Use the cursor buttons to move the cursor to the parameter that you want to edit, and
use the VALUE dial or [DEC] [INC] to set the value.
Specifying How Multi-Effects are Combined (MFX STRUCTURE)
Parameter Range Explanation
MFX Structure TYPE01–TYPE16 Specifies how MFX 1–3 will be combined
MFX1–3 00 (THRU)–79 Specifies the multi-effect type for each MFX 1–3
Chorus Settings (CHORUS)
Parameter
Range Explanation
(Chorus Type)
00:OFF–
03:GM2 CHORUS
Selects the type of chorus.
Choose “00: OFF” if you don’t want to apply chorus.
Parameters for each
chorus type
Set the parameters of the selected chorus type.
Refer to “Chorus Parameters” (p. 190).
Reverb Settings (REVERB)
Parameter
Range Explanation
(Reverb Type)
00:OFF–
05:GM2 REVERB
Selects the type of reverb.
Choose “00: OFF” if you don’t want to apply reverb.
Parameters for each
reverb type
Set the parameters of the selected reverb type.
Refer to “Reverb Parameters” (p. 191).
JUNO-STAGE_e.book 86 ページ ２００８年１０月１７日 金曜日 午後１２時２７分