Roland Juno-Stage - Playing the JUNO-STAGE from an External MIDI Device; Setting the Receive Channel; Setting the Program Change Receive Switch

90
Chapter 7. Connecting an External MIDI Device
Example Connections with an External MIDI
Device
fig.midi-receive
You’ll need to match your external MIDI device’s transmit channel with
the JUNO-STAGE’s receive channel.
Here we’ll explain how to make settings for playing the JUNO-STAGE
in Patch mode.
1. Press the [MENU].
2. Use [ ] [ ] to select “1. System” and press the [ENTER].
3. Press [4 (MIDI/SYNC)].
4. Press [2 (General)].
5. Use [ ] [ ] to select “Kbd Patch Rx/Tx Channel.”
6. Use the VALUE dial or [DEC] [INC] to set the value.
Range: 1–16
Here’s how to turn on the receive switch for program change and
bank select messages. With the factory settings, both are turned
“ON.”
1. Press [MENU].
2. Use [ ] [ ] to select “1. System” and press [ENTER].
3. Press [4 (MIDI/SYNC)].
4. Press [4 (RX)].
5. Use the cursor buttons to select “Receive Program Change” or
“Receive Bank Select.”
6. Use the VALUE dial or [DEC] [INC] to turn each of these “ON.”
7. To save your settings, press [WRITE].
If you decide not to save the changes you made, press [EXIT] to
return to the previous screen.
For details on these settings, refer to “[4 (RX)]” (p. 151).
For details on how to set the transmit channel of your external
MIDI device, refer to its owner’s manual.
If you’re using the JUNO-STAGE in Performance mode, you’ll
also need to make settings in the MIDI FILTER screen to specify
the “Rx (Receive Switch),” “PC (Receive Program Change),” and
“BS (Receive Bank Select)” setting for each part (p. 138), in
addition to the settings described above.
Playing the JUNO-STAGE from an
External MIDI Device
Setting the Receive Channel
MIDI sequencer
MIDI OUT
MIDI IN
JUNO-STAGE
Setting the Program Change Receive Switch
JUNO-STAGE_e.book 90 ページ ２００８年１０月１７日 金曜日 午後１２時２７分