Roland Juno-Stage - Changing the Pitch in Semitone Steps ([TRANSPOSE])

QUICK START
Selecting Sounds
34
The transpose function lets you change the pitch of the keyboard in semitone steps.
You can use this when you need to perform a transposing instrument such as trumpet or clarinet at the pitches
printed in the musical score.
fig.panel-trans.eps
fig.disp-trans.eps
While holding down [TRANSPOSE], press [-] or [+].
Specify the amount of transposition in semitone steps
(G–F#: -5–+6 semitones).
A setting window will open when you press the button,
and will close a short time after you release the button.
If the transposition value is other than “C,” the
[TRANSPOSE] will light.
Changing the Pitch in Semitone Steps ([TRANSPOSE])
JUNO-STAGE_e.book 34 ページ ２００８年１０月１７日 金曜日 午後１２時２７分