67
Chapter 3. Versatile Performance Functions
1.
Press [V-LINK] to access the V-LINK screen.
2.
Press [7 (SETUP)].
The V-LINK SETUP screen appears.
fig.V-LINK-SETUP
3.
Use [ ] [ ] to move the cursor to the parameter you want to
edit.
4.
Use the VALUE dial or [DEC] [INC] to set the value.
* :
On V-LINK compatible devices such as the Edirol DV-7PR/P-1,
only Note Tx Channel A is used.
In motion dive .tokyo Performance Package, the Note Tx Channel
corresponds as follows.
A:
The MIDI channel that controls section A
B:
The MIDI channel that controls section B
C:
The MIDI channel that controls the MIDI note plug-in
5.
If you want to keep your settings, press [7 (WRITE)].
6.
Press [6 (EXIT)] or [EXIT] to return to the previous screen.
V-LINK Settings (V-LINK SETUP)
Parameter
Value Explanation
Note Tx
Channel A
1–16
Controls the V-LINK
device. Specify the
MIDI channel. (
*
)
Note Tx
Channel B
Note Tx
Channel C
D BEAM
Assigns a V-LINK function to the D Beam
controller.
OFF
The operation
selected by D BEAM
buttons will occur
regardless of
whether V-LINK is on
or off.
ColorEQ Fore CC01 (Modulation)
Used with
motion dive
.tokyo
Performance
Package
ColorEQ Back CC71 (Resonance)
Scratch SW CC03
Speed Knob CC08 (Balance)
Total Fader CC10 (Panpot)
Cross Fader CC11 (Expression)
BPM Sync SW CC64 (Hold)
Clip Loop SW CC65 (Portamento)
Assign Knob CC72 (Release)
Fade Time SW CC73 (Attack)
Visual Knob CC74 (Cutoff)
AB SW CC81 (General-6)
Tap SW CC83 (General-8)
Total Select CC85
FX Select CC86
Play Pos CC91 (Reverb)
LoopStartPos CC92 (Tremolo)
Loop End Pos CC93 (Chorus)
LayerModeSel CC94 (Celeste)
Dissolve Time CC73 (Attack)
Used with the
DV-7PR and
similar devices.
Color Cb Ctrl CC01 (Modulation)
Color Cr Ctrl CC71 (Resonance)
Brightness Ctrl CC74 (Cutoff)
VFX1 Ctrl CC72 (Release)
VFX2 Ctrl CC91 (Reverb)
VFX3 Ctrl CC92 (Tremolo)
VFX4 Ctrl CC93 (Chorus)
Fade Ctrl CC10 (Panpot)
JUNO-STAGE_e.book 67 ページ ２００８年１０月１７日 金曜日 午後１２時２７分
To Next Page
Loading...
