135
Chapter 10. Detailed Editing for Performances
You can assign a variety of functions to controllers such as the D Beam Controller and the buttons.
CTRL SETTING (PERF) Screen
fig.disp-ctrlset.eps
In the PERFORM PLAY screen, press [3 (CONTROL)] to access this screen.
Use the cursor buttons to select the parameter you want to edit, and use the
VALUE dial or [DEC] [INC] to set its value.
The [2]–[7] buttons located below the display provide access to the edit screens
indicated in the bottom line of the screen.
When you’ve finished making settings, press [EXIT] to return to the PERFORM
PLAY screen.
For more about D Beam settings, refer also to “Using the D Beam Controller to
Modify the Sound” (p. 56).
Making Settings for the D Beam Controller and Other Controllers
Button
Content
[2 (TEMPO)]
Specifies the tempo of the performance.
[3 (S1/S2)]
Specifies the functions controlled by the [S1] and [S2] buttons.
[4 (DB ASGN)]
Specifies the function controlled by the D Beam controller.
[5 (DB EXP)]
Makes settings for when using the D Beam controller to control active expression. For details on these parameters, refer
to System settings “[4 (ATV EXP)]” (p. 153).
* These are system settings. To save them, press [7 (WRITE)] in the edit screen to save the system settings.
[6 (DB SYN)]
Makes settings for when using the D Beam controller as a monophonic synthesizer. For details on these parameters,
refer to System settings “[3 (SYNTH)]” (p. 152).
* These are system settings. To save them, press [7 (WRITE)] in the edit screen to save the system settings.
[7 (CTRL SW)]
Accesses the CONTROL SW (PERF) screen, where you can turn the controllers on/off for each part, and specify the
MIDI messages that they will transmit (p. 137).
* “[7 (CTRL SW)]” is not shown if [5 (DB EXP)] or [6 (DB SYN)] are selected.
JUNO-STAGE_e.book 135 ページ ２００８年１０月１７日 金曜日 午後１２時２７分
To Next Page
Loading...
