Roland Juno-Stage - PITCH (3 types)

185
Effects List
A stereo pitch shifter.
fig.MFX-61
Shifts the pitch of the original sound. This 2-voice pitch shifter has two
pitch shifters, and can add two pitch shifted sounds to the original
sound.
fig.MFX-62
A pitch shifter in which the amount of pitch shift is varied by a 16-step
sequence.
fig.MFX-63
You can use multi-effect control to make the step sequence play
again from the beginning (p. 164).
61:
PITCH SHIFTER
Parameter
Value Explanation
Coarse #1 -24–+12 semi
Adjusts the pitch of the pitch
shifted sound in semitone steps.
Fine #1 -100–+100 cent
Adjusts the pitch of the pitch
shifted sound in 2-cent steps.
Delay Time 0–1300 msec, note
Adjusts the delay time from the
direct sound until the pitch shifted
sound is heard.
Feedback # -98–+98%
Adjusts the proportion of the
pitch shifted sound that is fed
back into the effect. Negative (-)
settings will invert the phase.
Low Gain -15–+15 dB
Gain of the low range
High Gain -15–+15 dB
Gain of the high range
Balance # D100:0W–D0:100W
Volume balance between the
direct sound (D) and the pitch
shifted sound (W)
Level 0–127
Output Level
62:
2VOICE PITCH SHIFTER
Parameter
Value Explanation
Pitch1 Coarse #1 -24-+12 semi
Adjusts the pitch of Pitch Shift 1
in semitone steps.
Pitch1 Fine #1 -100-+100 cent
Adjusts the pitch of Pitch Shift
Pitch 1 in 2-cent steps.
Pitch1 Delay 0–1300 msec, note
Adjusts the delay time from the
direct sound until the Pitch Shift 1
sound is heard.
Pitch1 Feedback #
-98–+98%
Adjusts the proportion of the
pitch shifted sound that is fed
back into the effect. Negative (-)
settings will invert the phase.
Pitch1 Pan # L64-63R
Stereo location of the Pitch Shift
1 sound
Pitch1 Level 0–127
Volume of the Pitch Shift1 sound
L in
R in
Pitch Shifter
Pitch Shifter
L out
R out
2-Band EQ
2-Band EQ
L in
R in
L out
R out
2Voice Pitch Shifter
Level 1
Balance W
Balance D
Balance W
Balance D
Level 1
Pan 2 R
Pan 1 L
Pan 1 R
Pan 2 L
Pitch2 Coarse #2 -24-+12 semi
Settings of the Pitch Shift 2
sound.
The parameters are the same as
for the Pitch Shift 1 sound.
Pitch2 Fine #2 -100-+100 cent
Pitch2 Delay 0–1300 msec, note
Pitch2 Feedback #
-98–+98%
Pitch2 Pan # L64-63R
Pitch2 Level 0–127
Low Gain -15–+15 dB
Gain of the low range
High Gain -15–+15 dB
Gain of the high range
Balance D100:0W-D0:100W
Volume balance between the
direct sound (D) and the pitch
shifted sound (W)
Level 0–127
Output Level
63:
STEP PITCH SHIFTER
Parameter
Value Explanation
Step 01–16 -24–+12 semi
Amount of pitch shift at each step
(semitone units)
Rate # 0.05–10.00 Hz, note
Rate at which the 16-step
sequence will cycle
Attack # 0–127
Speed at which the amount of
pitch shift changes between steps
Gate Time # 0–127
Duration of the pitch shifted
sound at each step
Fine -100–+100 cent
Pitch shift adjustment for all steps
(2-cent units)
Delay Time 0–1300 msec, note
Delay time from the original
sound until the pitch-shifted
sound is heard
Feedback # -98–+98%
Proportion of the pitch-shifted
sound that is to be returned to the
input (negative values invert the
phase)
Low Gain -15–+15 dB
Amount of boost/cut for the
low-frequency range
High Gain -15–+15 dB
Amount of boost/cut for the
high-frequency range
Balance # D100:0W–D0:100W
Volume balance of the original
sound (D) and pitch-shifted sound
(W)
Level 0–127
Output volume
Parameter
Value Explanation
L in
R in
Step Pitch Shifter
Step Pitch Shifter
L out
R out
2-Band
EQ
2-Band
EQ
JUNO-STAGE_e.book 185 ページ ２００８年１０月１７日 金曜日 午後１２時２７分