11
Performance Control Section
Pitch Bender
This allows you to change the pitch of the DCOs.
The Bender is hard coded to the DCOs to enable
note bends but this is also three different Matrix
sources. The three types are Up only, Down only
or Both up & down. These can sent to any Matrix
destination.
LFO Trigger Button
This button will add modulation
and is a Matrix source. The
destination of this modulation can
be any of the Matrix destinations.
Bend Range Switch
This sets the Maximum effect of the bender.
• Wide...Maximum effect. This will be an
Octave for DCOs
• Mid...Medium effect. This will be a major
perfect 5th for DCOs
• Narrow...Smallest effect. This will be a
two semitones for DCOs
On all factory programs the LFO
button has a Matrix entry that will
give a moderate level of DCO LFO
level on both DCOs to give a
vibrato effect.
Brilliance Knob
This control sets the overall tone of the 3P. It
achieves this by altering the filter cutoff level for
all voices using the 3P hardware and will alter
any programmed filter settings.
Volume Knob
This sets the overall output level of
the 3P.
www.kiwitechnics.com Kiwi-3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
