48
Table 1.0 Command ID Data Byte Data Type
Byte details
7 ------- 0
Data Details
$01 (1) Request Global Dump
No Data 3P transmits a $02 (2) command
$02 (2) Transmit or Receive Global Dump
32 data bytes
$00 (0) = Midi Channel In 000yxxxx xxxx = 0-15 for midi channel 1-16
y = set for Omni
$01 (1) = Midi Channel Out 0000xxxx xxxx = 0-15 for midi channel 1-16
$02 (2) = Seq Midi Channel Out 0000xxxx xxxx = 0-15 for midi channel 1-16
$03 (3) = Enable MidiCC 000000xx xx = 00=Off
01=CC Receive Enabled (Default)
10=CC Transmit Enabled
11=CC Receive & Transmit Enabled
$04 (4) = Enable Sysex 0000000x x = Off/On (set=On)
$05 (5) = Enable Program Change 000000xx xx = 00=None
01=PC Receive Enabled (Default)
10=PC Transmit Enabled
11=PC Receive & Transmit Enabled
$06 (6) = Midi Soft Through 000000xx xx = 00=Stop all
01=Pass all
10=Pass only nonCC
11=Stop only CC we have used
Note - SysEx intended for the Kiwi-3P will not be passed
Note – Active Sensing commands are suppressed within the Kiwi-3P
and are not passed on
$07 (7) = Enable Midi Clock Gen 0000000x x = Off/On (set=On)
$08 (8) = Master Clock Source 0000000x x= 0-Internal
1-Midi
$09 (9) = Master Fine Tune 0xxxxxxx x = Master Fine Tune (+- 100 cents)
$0a (10) = Clock Display 0000000x x= 0-Off
1-On
$0b (11) = Guitar Mode 0000000x x = Off/On (set=On) – Note this uses midi channels 1-6 only
$0c (12) = Pedal Control 0000000x x= Sets Hold Pedal Polarity
$0d-$1f (13-31) = Nulls Not Used
$03 (3) Request Tone Edit Buffer Dump
No Data
www.kiwitechnics.com 3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
