20
Setting up with External Devices
External Clock
You can adjust the tempo, and start
or stop the Arpeggiator and/or
Sequencer of the JX-3P with the
controls on the external unit.
Before starting external
synchronization with the external
unit, make sure that the built-in
sequencer in the JX-3P is not
running. Press the Start/Stop
button and it's indicator will light
then start the synchronization.
Midi Notes
If your JX-3P has Midi though fitted
this should be used if multiple units
are being used on the midi chain to
reduce delays. Full midi command
details are at the end of the manual.
Hold Pedal
The Roland DP-2 is shown but any
pedal that shorts the tip can be
used. The polarity of the hold
pedal is autosensed when the
Kiwi-3P Matrix is powered on. For
this work correctly the Hold Pedal
should not be pressed as the
synth is powered on. There is a
Global Parameter (GA:2:5) that
lets you change the polarity of the
pedal so the autosense can be
overridden until the 3P is switched
off.
The Hold Pedal is a matrix source
which can be sent to any
destination.
PG-200 Controller
The PG-200 can be used with the
Kiwi-3P Matrix upgrade. Only the
parameters on the PG-200 can be
edited using this. Edits are made
to the edit buffer only and will
need to be saved to memory if
you wish to keep them.
www.kiwitechnics.com Kiwi-3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
Need help?
General
