4
Kiwi-3P Matrix Features
• 1024 Tones & 8 Sequences can be stored and edited, Sequences can be optionally linked to tones. It is also possible to
temporarily edit any Tone or Seq
• Pulse Width Module is included with the Kiwi3P Matrix. This allows Pulse Width control and wave combinations.
• Saw, Pulse Width & Square Waveforms can be solo or mixed in any combination.
• Sysex support for all and MidiCC for most parameters, Midi Sysex support for Tone Dump & Load
• Patch Editor Control of Parameters (requires PE v 8.3 or later)
• Full Matrix system with 29 Source and 40 Destination types.
• Key Assign Modes are Poly Single, Poly Dual, Poly Triple, Unison & Solo
• Each Key Assign mode can have Rotate/Reassign, Staccato/Legato, Steal/No Steal with five steal modes (Highest, Lowest,
Oldest, Newest, Quietest)
• Portamento in all key modes
• Note Detune available in all key modes, DCO 1 & 2 have separate Tune controls (±12 semitones) and DCO2 has a Fine Tune
(±50 cents). There is also an Analogue Feel parameter that adds a small random detune to notes.
• Master Synth Fine Tune adjust in both hardware and software.
• Three independent envelope generators. These are traditional ADSR type and are modeled on the Original JX-3P. Each ENV
Mod can select from ENV 1 - 3 and has an Inverted or Normal modes. These are faster than the traditional JX-3P envelopes
• Three independent Low Frequency Oscillators with 6 waveforms each. Each LFO Mod can select from LFO 1-3. LFOs can be
plus and minus base note or plus base note only.
• Midi Note Aftertouch (Channel & Note), Midi and Internal Modulation Level and Midi Note Dynamics are all Matrix sources
and can be sent any Matrix Destination.
• LFO Button is a Matrix Source and can inject mod control to any matrix destination(s)
• Bend Lever is coded to DCO Frequency for Bend but is also a Matrix Source which can be sent to any Destination
• Front panel editing is available for all parameters. These can be edited via midi or the PG-200.
• Master, Sequencer and Arpeggiator clocks can optionally display on the front panel
• Key transpose allows transposition to any key. The range for this is -1 Octave to +2 Octaves
• Chorus has Manual Mode & variable speed
CHORD MODE
• Any chord with up to 6 notes can be set and played from any key
ARPEGGIATOR
• The Arpeggiator is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
• Arp modes are Up, Down, Up and Down, Random, As Played, 1, 2, 3 or 4 octaves
• Arp can be Started, Stopped & Continued using Midi Commands
• Appeggiator will Output Midi Data
SEQUENCER
• 8 separate 124 Max step Polyphonic sequences can be created and stored
• Sequences can be edited
• The Sequencer is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
• Sequencer can be Started, Stopped & Continued using Midi Commands
• Sequencer will Output Midi Data
PG-200
• Full PG-200 support
• PG-200 will output midi data
www.kiwitechnics.com Kiwi-3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
Need help?
General
