58
$0a (10) Transmit/Receive Seq Dump
Seq Number + 917 data bytes
Sequence Number 0000xxxx x = 0-7 for Sequence 1-8
WARNING! This command will overwrite the
current sounding Seq with the Seq
selected
$00 (0) = Seq Length 0xxxxxxx x = 0 = No Seq Recorded
1-124 = No of Seq Steps
$01-$14 (1-20) = Seq Name 20 Ascii Bytes Sequence Name
$15-$395 (21-917) = Seq Steps 128 x 7 (896)
Note 1 axxxxxxx
Note 2 bxxxxxxx
Note 3 cxxxxxxx
Note 4 dxxxxxxx
Note 5 exxxxxxx
Note 6 fxxxxxxx
Byte 7 00abcdef
Each Step is 7 bytes
xxxxxxx = note number (32-96)
Bits a-f are removed from each note byte and placed in the 7th
byte. The a-f note bits are then set to zero
Note Bytes are $00 (0) if not used
Each used step byte is a note number (32-96) and the bits a-f
are set if the note has been tied to the previous note.
Table 1.0 Command ID Data Byte Data Type
Byte details
7 ------- 0
Data Details
$0d (13) Request Edit Buffer Tone Parameter
1 Data Byte
$00 (0) - Tone Parameter Number
Data format the same as $04
Parameter Number is Data Posn
0xxxxxxx x = Data Offset
Use Data Position for Parameter Number
e.g. $15=DCO1Tune
3P transmits a $0e (14) command
$0e (14) Transmit / Receive Edit Buffer Tone
Parameter
2 data bytes
$00 (0) - Tone Parameter Number
Data format the same as $04
0xxxxxxx x = Data Offset
Use Data Position for Parameter Number
e.g. $15=DCO1Tune
$01 (1) - Parameter Value 0xxxxxxx Data format depends on Parameter
Data format the same as $04
$0f (15) Request Global Parameter
1 Data Byte
$00 (0) - Global Parameter
Number
000xxxxx x = Data Offset
Use Data Position for Parameter Number
Data format the same as $02
e.g. $0a (10) = Midi Channel In
$10 (16) Transmit/Receive Global Parameter
2 data bytes
$00 (0) - Global Parameter
Number
000xxxxx x = Data Offset
Use Data Position for Parameter Number
Data format the same as $02
e.g. $0a (10) = Midi Channel In
www.kiwitechnics.com 3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
