33
Step 5) Carefully solder in the supplied 40 IC socket.
Step 6) Fit the KiwiTechnics 3P Matrix Upgrade Board into the socket. Note that there is already a socket pressed onto the cpu board. This
is there to lift the Kiwi-3P Matrix board above the capacitors that are to the left of the cpu socket and should be left in place. Pin 1
on the upgrade board is marked and this end MUST be at the pin 1 end of the socket . Pin 1 is marked on the socket &
upgrade board by a notch in one end (see pictures) and is at the keyboard end. It is most important to make sure all the
pins are located inside all the socket holes before pressing the upgrade firmly into the socket. This will need a firm
push to seat and if pins are not located correctly they will bend and are likely to break off which will require a replacement.
Step 7) The white wire on the Kiwi-3P CPU board will be fitted to the Midi board in the next part of the install. Do not refit the main board
yet.
www.kiwitechnics.com 3P Matrix Upgrade User Manual v1.2
To Next Page
Loading...
