Roland R-07 Reference Guide

8
Getting Ready
Preparing a microSD Card
Inserting a microSD Card
Inserting
1. Make sure that the power is o.
If the power is on, turn it o.
2. Open the microSD cover located at the top of the
unit.
Insert your ngernail into the notch in the microSD cover, and pull
it upward.
The cover may break if you use excessive force.
3. Insert the microSD card.
Insert the microSD card in the same orientation as shown in the
illustration.
NOTE
5 Forcibly inserting the microSD card in the wrong orientation
may damage the R-07 or the microSD card. Please use
caution.
5 Press the microSD card rmly all the way in.
5 Since a microSD card is small, take care not to lose it when it
is ejected.
4. Close the microSD cover.
5. Slide the [POWER] switch toward POWER for several
seconds to turn on the power.
MEMO
If an unformatted microSD card is inserted in the R-07, the
screen will indicate “SD Unformatted.”
Removing an microSD card
1. Switch o the R-07’s power.
2. Open the microSD cover.
3. Gently press the microSD card inward, and then
release your nger.
When the microSD card pops out, remove it.
NOTE
Do not insert or remove a microSD card while the power is
on. The data on the microSD card may be lost if you do so.
About microSD cards
NOTE
5 The R-07 supports microSD/microSDHC cards.
5 Some microSD card types or memory cards from some manufacturers may not record or play back properly on the R-07.
5 Never insert or remove an microSD card while this unit’s power is on. Doing so may corrupt the unit’s data or the data on the microSD
card.
5 Carefully insert the microSD card all the way in—until it is rmly in place.

Roland R-07 Specifications

General

Sample rate	96 kHz
Audio quality	24 bit
Frequency range	20 - 40000 Hz
USB 2.0 ports quantity	1
Product color	Black

Weight and Dimensions

Weight	150 g
Dimensions (WxDxH)	61 x 103 x 26 mm