Roland R-44 - Other Settings

31
Recording
● Record button [REC]
If you want to begin recording immediately, press the [REC] button.
● Other settings
If you want to monitor the sound being recorded, connect headphones to the PHONES jack and use the
Monitor level knob to adjust the volume.
Adjusting the Monitor level knob does not affect the level of the sound actually being recorded.
To play the recorded sound, refer to “Playing Back” (p. 41).
Recording standby
If you want to put the R-44 in recording standby
mode to be ready to record, hold down the
[PAUSE] button and press the [REC] button.
During recording standby, the [REC] button blinks and the
indication alternates between REC and STANDBY.
When recording is paused, the [REC] button blinks. In
addition, the indication alternates between REC and
PAUSE.
Press the [REC] or [PAUSE] button during recording
standby or while paused to start recording.
You can adjust input levels during recording standby.
Recor
d
ing-stan
db
y
R-44_e_new.book 31 ページ ２００８年５月１５日 木曜日 午後４時５３分