54
Manipulating a Project (Finder)
This feature allows you to repair files that cannot be played because of an accident during recording, such
as mistakenly disconnecting an AC adaptor or removing the SD memory card.
fig.finder-1.eps
1
Press the [ENTER/FINDER] button while the Main
screen is shown in the display. The Finder screen shown in
the illustration will appear.
Projects are shown in descending alphabetical order.
fig.finder-select.eps
2
In the Finder screen, use the Cursor buttons [ ] [ ]
or the [SCRUB/VALUE] dial to select the project that you
want to repair. Then press the [ENTER] button.
When a folder is selected, you can press the Cursor button [] to move into the selected
folder (i.e., move to a lower-level folder).
If you want to move back to the upper-level folder, press the Cursor button [ ].
fig.repair1-menu.eps
3
When the screen shown in the figure is displayed, use the
Cursor buttons [ ] [ ] to select 6 Repair. Then press
the [ENTER] button.
* “6 Repair” is displayed only when the R-44 detects a damaged song.
ig.repar.eps
4
When the screen shown in the figure is displayed, press
the [ENTER] button to confirm the operation.
fig.repair-proce.eps
* Do not turn off the power or remove the SD memory card while a
project is being repaired.
* This feature cannot repair all projects.
fig.ne
Repairing a Project (Repair)
R-44_e_new.book 54 ページ ２００８年５月１５日 木曜日 午後４時５３分
To Next Page
Loading...
Need help?
General
